Auto Dispensing

Automatic Dispensing system sometimes referred to XYZ robotic dispensing offer a competitive range in many applications in the demanding market today generally in Dam & Fill, Chip On Board (COB), Undefill, Potting, Dotting, Solder Paste, Die Attached Material and SMT glue dispensing. Dispensing Series introduce a wide range of selection to suit the requirement and flexibility of each application.

With Auto Mass Calibration features on the viscosity control, the changes of the viscosity on the material is adjusted through its flow rates and determine a consistency amount of volume dispense out from this system.

Pattern Recognition System (PRS) will optimize the fiducial capturing for each substrate.

Laser Height Sensor incorporated with this system reduces the cycle time and increases the output.

Dam	Fill	Underfill

Chip On Board (Glob top)	Dotting	Gasketing

Dispenser Series

Several models can be selected to match your requirement on the production to higher yield and higher production outputs.

1 ROBOT, 1 LANE CONVEYOR (SINGLE HEAD)
	Single head dispensing makes perfect for a process use only 1 type of material. Commonly applicable for Underfill, Chip On Board (COB) or single component adhesives dispensing.
MODEL FDS-1000
1 ROBOT, 2 LANES COVEYOR (DUAL HEAD)
	Produces 1 dispensing head with 2 conveyors in one machine makes a dispensing process produces higher output eliminating waiting time while transporting a substrate to a dispense station.
MODEL FDS-2000
2 ROBOTS, 2 LANES
	2 different Dispensing head in one machine makes every single head travel to each conveyor and perform its dispensing with its own programmed pattern. Hence, flexibility of pattern could be established using 2 different head and increase productivity to your output.
MODEL FDS-1500
2 ROBOTS, 1 LANE
	2 different dispensing head using single lane conveyor allow each dispensing head attach with 2 different adhesives in different viscosity into a process eliminating dispensing using 2 machines.
MODEL FDS-1300J

Various Pump Series

Jet pump	Linear Pump	Large Pitch Screw Pump

Micro Pitch Pump	Piston Pump

Introducing NEW Jetting Pump

Newest Pump uses Jetting Technology with cycle time as high as 1000 dots/min.

This Jetting dispensing valve provides highest speed in fluid jetting delivering the dots from a height between 1mm - 3mm above the board. In addition, it minimizes problems with adhesive stringing. Different sized dots can be applied by simply programming the valve to jet multiple shots into the same location. Thus, the jetting today gives a highest speed, tight process control, better repeatability and dot consistency that require by the industrial application today.

Benefits & Advantages :

• Eliminates Z-axis motion during dispensing.


• Positive shutoff gives no backtrack & prevent stringing issues.


• High Dispensing speeds achieved 1000 dots/min


• Possible to dispense a tighter space compare to needles.


• Reduce the chances of clipping die.


• Fluid stream can be placed in areas where needle will not fit in.


• Adaptable for the use of prototypes to high-mix, low volume in line production.

Valve Specifications :

• Sizes : 180 x 85 x 50 (mm)


• Weight : 850g


• Motor Power : 50W


• Max Speed : 6000 cycle dots / min


• Working Height : 1 -3 mm